Read More... Read More... Read More...

Automotive Recalls - March 2010

 


Automotive Recalls,
Continued

 


2008-2010 Toyota Highlander; 2009-2010 Toyota Corolla, Matrix, Venza
More than one million Toyota vehicles could have an accelerator problem. The accelerator pedal can get stuck in the wide-open position due to its being trapped by an unsecured or incompatible driver’s floor mat. (Note: This recall is an expansion of a campaign of 3.8 million other Toyota vehicles announced in 2009 for the same issue.) A stuck accelerator pedal may result in very high vehicle speeds and make it difficult to stop the vehicle, which could cause a crash, serious injury or death. Toyota will modify or replace the accelerator pedals on the subject vehicles. Floor surface modifications are also being considered and will be included for any model for which it is deemed appropriate. Initially, dealers will be instructed on how to reshape the accelerator pedal for the repair. As replacement parts with the same shape as the modified pedal become available, they will be made available to the dealers for the repair. Customers who have had the pedal reshape remedy completed will have the opportunity to receive a new pedal if they desire, after replacement pedals become available. In addition, Toyota will replace any Toyota all-weather floor mat in a subject vehicle with a newly designed mat, free of charge. For those customers who have the previous design all-weather floor mat but do not need or want the newly designed all-weather floor mat, Toyota will recover the previous design all-weather floor mat and reimburse its price.

2010 Pontiac Vibe


2009-2010 Pontiac Vibe

Nearly 71,000 Pontiac vehicles could have an accelerator pedal problem. Due to the manner in which the friction lever interacts with the sliding surface of the accelerator pedal inside the pedal sensor assembly, the sliding surface of the lever may become smooth during vehicle operation. In this condition, if condensation occurs on the surface, as may occur from heater operation (without A/C) when the pedal assembly is cold, the friction when the accelerator pedal is operated may increase, which may result in the accelerator pedal becoming harder to depress, slower to return, or, in the worst case, mechanically stuck in a partially depressed position, increasing the risk of a crash. Dealers will install a reinforcement bar in the accelerator pedal which will allow the pedal to operate smoothly. This service will be performed free of charge.


2009-2010 Dodge Ram; 2010 Chrysler Sebring, Dodge Avenger, Dodge Nitro, Jeep Commander, Jeep Grand Cherokee, Jeep Liberty
Nearly 20,000 Chrysler vehicles could have a brake problem. Certain vehicles may have been built with an improperly formed or missing brake booster input rod retaining clip. This could result in brake failure without warning which could cause a crash. Chrysler will replace the brake booster input rod retaining clip free of charge.


2010 Acura MDX
Approximately 644 Acura vehicles manufactured between October 7, 2009 and November 14, 2009 could have a trim problem. A bolt used to attach an interior trim piece to either the driver’s or passenger’s side A-pillar may not have been installed during manufacturing. In the event of a crash resulting in side curtain airbag deployment, the trim piece may not remain properly secured to the A-pillar, increasing the risk of injury to the driver and/or front seat passenger. Dealers will inspect the interior trim piece of the A-pillar and, if a bolt is missing, it will be installed free of charge.


2006-2007 Honda Ridgeline
More than 129,000 Honda pickups could have an instrument panel problem. On certain vehicles manufactured between January 17, 2005, and June 7, 2006, a wiring harness connector for the heating, ventilation and air conditioning (HVAC) blower motor located under the passenger’s side of the instrument panel may be accessible to kicking by the front seat passenger’s feet. If this occurs, the connector terminal may overheat, and this may cause the wire insulation to melt or the wiring connector to melt. Should the wiring insulation melt and the exposed wires make contact with each other (short circuit), a fire may occur. Dealers will inspect the wiring and, if the wiring connector is damaged, it will be replaced; all vehicles will have the protective cover installed free of charge.




Back
[ 1 ] [ 2 ]

[Printer-friendly version]